With regard to our two-day technical after-sales inspection service, we now give the following comprehensive analysis of the status quo of a batch of sole washing machines purchased by a large enterprise. The existing problems can be solved by your company in coordination. The reasons for the failure and damage of sole cleaner used by a large enterprise are as follows:
1. & nbsp; & nbsp; & nbsp; excessive pedestrian traffic, equipment overload
Through two technicians'on-site inspection, there are too many people in the workshop through the automatic sole cleaner, reaching more than 1000 people per day, while only one medium-sized sole cleaner is placed in the corridor, which can not meet the number of factory passers-by.
Suggestion: Buy a large size sole cleaner, at least two in each passage.
2. & nbsp; & nbsp; the water pressure of the inlet pipe of sole cleaner is too low to change water normally
Through on-site technical testing, the water pressure in the water intake channel installed by the factory is too low, and the equipment can't change water normally, resulting in too low water level, unable to replace the clean water of the equipment normally, resulting in the accumulation of debris and sludge in the equipment, causing damage to the brush belt, and greatly increasing the load of the equipment operation.
Suggestions: Replacement of water intake system and enhancement of water pressure
3. & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp
After the company appointed technology and your company and users to accompany inspection, found that the shoe sole cleaning machine inside a lot of debris, sludge, cards, similar foam, dust sticky residue, pin and so on.
Suggestion: Clean up the garbage once a day in the sink, and thoroughly clean up the garbage every seven days under the support ribs and signs.
4. & nbsp; & nbsp; improper maintenance, inadequate fitting
Through technical inspection, it was found that the loosening and dislocation of the screw in the bearing position occurred after the screw was lost or replaced, which resulted in serious wear of the bearing and the large axle of the equipment. The incorrect installation of the waterproof cover of the control box causes rust damage to the water intake of the control box.
Suggestion: Equipment parts replacement personnel carefully check to ensure that the installation is in place.
5. & nbsp; & nbsp; water pump damaged by blockage of drain pipe, uneven water level of equipment is low
The technicians found that the drainage pipeline was blocked and the pump could not work properly, causing damage to the pump. Low water level, resulting in water shortage in the equipment, equipment tilt, leading to the water level sensor can not accurately detect the actual water level.
Suggestion: Check and dredge drainage pipeline to ensure smooth. Adjust the horizontal placement of equipment.
To sum up, through two technicians appointed by our company, after a two-day inspection, we found that the problems in the use of sole cleaner in your company are serious, not the hardware problems of our products, but caused by users and your maintenance personnel. Please pay attention to them and correct them in time.